Port forwarding and Tomato

The_Other_One

The_Other_One

VIP Member
I'm dumbfounded here... There must be a glitch in the firmware or I'm just missing something simple. The rule is enabled, set to TCP, Scr is 192.168.1.2 (the address of the NAS), Ext port is 80, int port is 30, int address is 192.168.1.2. If I DMZ this address, everything works. This is a very basic site so it shouldn't require anything more than the HTTP port. Heck in the old router/firmware, I had it going just fine!
 
I just went to DD-WRT again and the stupid thing started working again. I still don't quite understand why it wasn't working, but it was obviously a problem with the firmware/installation.
 
What? It turned out to be a firmware/software issue. I know what I'm doing is correct because it worked using my old setup and is working using my new setup.

And I'm using port 30 for a few reasons. But mostly, the "server" is my NAS. Using port 80 would screw up the configuration page, so I just use 30 and forward it.
 
ohw i know. its just, 9 out of 10 times that people blame "the software" they really just made a mistake configuring the thing (no offense) also happened to me a couple of times.
 
You must log in or register to reply here.
Back
Top