raised motherboard

[jamesd1981]

hi guys i am having some problems getting boards to fit budget case, i bought a couple of budget cases to transfer internals from other towers, but the floor of the cases have bumps, so when i put in board standoff screws, it then raises the board to high to fit all the usb and audio connectors into the push in slot, any ideas any advice much appreciated.

 

[TFT]

If the case has "raised bumps" then the standoffs are not needed. Just be sure to use the insulated washers where needed though.

 

[jamesd1981]

If the case has "raised bumps" then the standoffs are not needed. Just be sure to use the insulated washers where needed though.

thanks tft i have some of the washers but they seem pretty thin are they def enough to prevent board touching case floor, do i need special screws to fix the board to the bumps i tryed the same screws i use with the standard risers but thread isnt wide enough to catch.