Dave Cummings
New Member
Hey all,
Firstly a little bit of back ground info. I work in IT, and have done for over ten years, but still everyone needs a bit of advice. The basics around this project is that I am a little obessed with the SETI project.
Ok I have been donated a Compaq Armada E500 laptop without a HDD by a friend, its a 600mhz CPU with 386mb ram, more than enough to run windows XP which it has done quite well in the past.
Now then, I want to build this laptop to be a slient as possible without causeing damage to the laptop.
I have ordered a Compact Flash IDE convertor to allow me to run a Compaq Flash card as a IDE drive.
Now what I want to do is run the Bionic software to run the SETI project, but i am a little unsure of what O/S to run it on. It will run on everything from windows 98 upwards and Linux.
I have never used Linux btw
Should I run this on Windows 98? and also I cant remember what the min specs are - would a 2gb compact flash be good enough for this project?
cheersb in advance
Firstly a little bit of back ground info. I work in IT, and have done for over ten years, but still everyone needs a bit of advice. The basics around this project is that I am a little obessed with the SETI project.
Ok I have been donated a Compaq Armada E500 laptop without a HDD by a friend, its a 600mhz CPU with 386mb ram, more than enough to run windows XP which it has done quite well in the past.
Now then, I want to build this laptop to be a slient as possible without causeing damage to the laptop.
I have ordered a Compact Flash IDE convertor to allow me to run a Compaq Flash card as a IDE drive.
Now what I want to do is run the Bionic software to run the SETI project, but i am a little unsure of what O/S to run it on. It will run on everything from windows 98 upwards and Linux.
I have never used Linux btw
Should I run this on Windows 98? and also I cant remember what the min specs are - would a 2gb compact flash be good enough for this project?
cheersb in advance