usb 3.0 pin fix

Discussion in 'Motherboards' started by volcano1, Oct 8, 2019.

  1. volcano1

    volcano1 Member

    Messages:
    88
    i bent a usb 3.0 header pin and it broke off while trying to bend back into place. so far it does not seem to affect use. but is there a way to fix it? it the second from bottom on left in the picture i believe is IntA_P2_D-. I am looking to sell my board and upgrade.
     

    Attached Files:

    Last edited: Oct 8, 2019
  2. johnb35

    johnb35 Administrator Staff Member

    Messages:
    41,743
  3. Okedokey

    Okedokey Well-Known Member

    Messages:
    9,506
    ntA_P2_D- and IntA_P2_D+ (and the equivalent P1 pins on the other side of the connector) are the data pins used for backwards compatibility with USB 2.0, those are the two wires through which usb 2 devices communicate and transfer data.
     

Share This Page