Da Mail Man
Active Member
Greetings all - It's been a while,
1)...I acquired (at "0" cost) a TP-LINK Archer C7 AC1750 Wireless Dual Band Gigabit Router and started fooling with it today...
2)...I wanted to look at the interface of the unit so, I connected a cable to one of the 4 ports on back of the "tp",
3)...then, ran to a laptop computer using Win 10,
4)...typed in 192.168.1.1 and computer screens says in effect; "could not connect"...
5)...The router was set to all it's defaults prior and all cables are good and laptop ok..
What am I doing incorrectly?
1)...I acquired (at "0" cost) a TP-LINK Archer C7 AC1750 Wireless Dual Band Gigabit Router and started fooling with it today...
2)...I wanted to look at the interface of the unit so, I connected a cable to one of the 4 ports on back of the "tp",
3)...then, ran to a laptop computer using Win 10,
4)...typed in 192.168.1.1 and computer screens says in effect; "could not connect"...
5)...The router was set to all it's defaults prior and all cables are good and laptop ok..
What am I doing incorrectly?
Last edited:
