WEP Problem

J

Joe

New Member
Hi to all.
I have installed and connected the following devices together:
MSI RG60G Router and Conceptronic C54APM which I have configured as a repeater to MSI to extend the connectivity.
I managed to connect them together and pc works fine when connected through the repeater.

The problem starts as soon as I enable the WEP in MSI...connection stops.
I have tried all sorts but cannot figure out what is wrong.
I an using the same MAC address on both devices.

I am sure it is a small thing.

Any help will be appreciated.

As soon as I disable the WEP on MSI the connection is on again.

Thanks
Joe
 
Don't use WEP, it's useless and could be hacked in under 10 minutes. Use WPA at a minimum, but you should be using WPA2. If WEP is your only option on the Conceptronic AP, you should honestly throw it in the trash and replace it with something more current.
 
The WEP key is for both conceptronic access and router access.
so 1 key for both devices.
 
Last edited:
I have updated firmware to 1.26 and connection is up and running.

Thank you.

Joe
 
Last edited:
You must log in or register to reply here.
Back
Top