Greg J.
VIP Member
Here is the situation: Every couple of weeks, my computer will overheat to around 61 degrees Celcius. I have been monitoring it with SpeedFan and the temperature is normally 23 to 25 degrees but has been running in the thrities, as much as 40 on daily long use.
The history behind the original overheat was that the original CPU fan ball bearings were worn and slipping, thus the fan sometimes stopped running. Since I could not find a new fan (simply held to the heatsink by four screws) after much searching, I bought a new, official Intel Socket 478 heatsink and fan from a licensed computer repair shop.
I took the new Intel kit home and could not loosen the CPU from the old heatsink. In the end, the CPU was pulled out of the socket because a thick layer of thermal epoxy from the factory would not budge. I didn't want to risk damaging the CPU (had already bent a pin and broke one of the two retention bracket pieces, ), so I had the people at the computer shop install it (buy a part from them, get free installation) with a new bracket piece and new thermal compound for the new heatsink and fan set, everything turned out great. The system once again ran at 23 to 25 degrees Celcius. Now it occasionally overheats and the system runs very slow.
I currently have a floor fan behind the case to blow air into it. The computer is running at a steady temperature of about 36 degrees.
I have a screenshot of SpeedFan and fairly normal temps. The only thing that isn't working correctly is the CPU fan. It throttles from about 2300 rpm to 2790 rpm. The power supply voltages read normal and do not fluctuate more than .03 of a volt.
I asked about a factory warrenty in the computer repair shop for the new HSF (total event happened two months ago over the course of two days), but there is no factory warrenty.
To solve this problem, the only logical solutions that I can come up with are that: 1. I need to install a case fan 2. I need to get a power supply that can move more air, 3. The retention brackets aren't installed precisely 4. I should bring the computer back to the shop to have them look at it 5. The wires inside my computer case are messy and need to be organized.
As of now, I will continue to run SpeedFan, reduced into the system tray, to keep an eye on the temperature. I would like to know if there is anything else that I can do to improve the temperature. I have been trying to buy the best micro-ATX power supply out there to expand the amount of components and to move more air, but to no avail.
If someone could give me a few suggestions on the temperature issue and point me to the best 24-pin Intel-based power supply out there, I will be very relieved because my family will be able to use this computer for the next four years as replacing parts is cheaper than buying a whole new system. Everything else about the computer runs with no problems or errors.
The history behind the original overheat was that the original CPU fan ball bearings were worn and slipping, thus the fan sometimes stopped running. Since I could not find a new fan (simply held to the heatsink by four screws) after much searching, I bought a new, official Intel Socket 478 heatsink and fan from a licensed computer repair shop.
I took the new Intel kit home and could not loosen the CPU from the old heatsink. In the end, the CPU was pulled out of the socket because a thick layer of thermal epoxy from the factory would not budge. I didn't want to risk damaging the CPU (had already bent a pin and broke one of the two retention bracket pieces, ), so I had the people at the computer shop install it (buy a part from them, get free installation) with a new bracket piece and new thermal compound for the new heatsink and fan set, everything turned out great. The system once again ran at 23 to 25 degrees Celcius. Now it occasionally overheats and the system runs very slow.
I currently have a floor fan behind the case to blow air into it. The computer is running at a steady temperature of about 36 degrees.
I have a screenshot of SpeedFan and fairly normal temps. The only thing that isn't working correctly is the CPU fan. It throttles from about 2300 rpm to 2790 rpm. The power supply voltages read normal and do not fluctuate more than .03 of a volt.
I asked about a factory warrenty in the computer repair shop for the new HSF (total event happened two months ago over the course of two days), but there is no factory warrenty.
To solve this problem, the only logical solutions that I can come up with are that: 1. I need to install a case fan 2. I need to get a power supply that can move more air, 3. The retention brackets aren't installed precisely 4. I should bring the computer back to the shop to have them look at it 5. The wires inside my computer case are messy and need to be organized.
As of now, I will continue to run SpeedFan, reduced into the system tray, to keep an eye on the temperature. I would like to know if there is anything else that I can do to improve the temperature. I have been trying to buy the best micro-ATX power supply out there to expand the amount of components and to move more air, but to no avail.
If someone could give me a few suggestions on the temperature issue and point me to the best 24-pin Intel-based power supply out there, I will be very relieved because my family will be able to use this computer for the next four years as replacing parts is cheaper than buying a whole new system. Everything else about the computer runs with no problems or errors.
Last edited: