CPU - 3.3 ghz or not?

unfortunately I can't find one of those so I have to go with the adaptor I said from before

To make this work I need to plug 1 intake fan into the mobos 3pin sys fan 12 V plug, and the other intake and exhaust into the adaptors 12 V plugs. Right?

There's so much cables in my comp gonna be hard but I think I can manage :p

I'm going out now I'll be back at 8 or so
 
You could plug in the back exhaust fan into the board header by the 24 pin power connector. Then use a adaptor like this to plug the 2 side fans into the board header by the Sata port.

Edit, So they dont have a adaptor like this one. Just use the one by the 24 pin power conector for the back fan and use the first adaptor you showed me on the 2 12V lines for the side fans.

C184-27391.jpg
 
Last edited:
Where can I find the 24 pin power connecter and the header where i need to plug in the back fan?
 
Last edited:
Ok since I'm getting it tomorrow can I have a quick reply.

Will it work if I plug 1 intake into the 3 pin port in the motherboard and the other 2 fans into the 12 v ports in the molex adapter?
 
thanks for the late reply but someone already answered my question and gave me lots of info

I also decided to take the sleeve bearing version of the 50x50

I hope this will give some good results

Ill need to move some cables for better airflow when I'm mounting the fans
 
Like everyone else says get a rear fan to take the hot air out of case. Also you might want to do some cable managment.
 
Ok so I got the 3 fans, and they all work when I plug them in.

The only problem is installing them so they stay on the case. They do not come with any sort of screws. I do have the right screws for the 80x80 fan but it can fall off so I need to get some bolts on the otherside so it's sturdy.

As for the 50x50 fans it's a different situation. The holes for the screws are thinner than the 80x80 fan but the holes in the case where I will be mounting the 50x50 fans are bigger than the holes in the 50x50 fans so I will also need to get some bolts and to screw them on the otherside so the fans don't fall off.

:(
 
I'm pissed.

I found that a 80x80 fan would fit on the side panel and one of the 50x50 fans would fit right next to it for huge CFM. Now I have 2 shitty 50x50 fans.

Should I get another 80x80 or stay with the 50x50. I know that if the 80x80 is better I can just get another one but the store is pretty far away and my dad also drove there and doesn't want to go again.

://
 
The screws you use on case fans are slighty larger than the fan holes and you screw them in from the case side into the fan. (From the holes in the case into the fan hole)

2357_1.JPG



CaseFan-Screws.jpg

CaseFan-Inside.jpg
 
Dont get some to big or it could crack the fan housing. Just large enough to use a little force screwing them in.
 
Ok so I tried it and it does work but I will need to buy some screws but I might get some that are too big or too small
 
Last edited:
I managed to put just the intake on at the side and temps rose by 3 degrees probably cause the case is on now

Do you guys think itll go lower after I mount the other fan and the exhaust?

its quite loud btw.
 
Temperatures are warmer by up to 5 'C, I took off the intake but left the exhaust

thx for all the help
 
Last edited:
You must log in or register to reply here.
Back
Top