Bigshow1030
New Member
I am not sure if this is where I need to put this particular question so I apologize in advance if it is in the wrong place. I have used a boot disk to go in and remove the old partition in my harddrive and then I have put a new partition in it and then formated it and that worked fine. I put my windows xp disc in to start putting windows on there and that starts great and then about 2 minutes into it it comes up with a error message that states :
USBEHCI.SYS is corrupted press key to continue, so I do that and then it says Setup Failed press key to reboot computer and then it does it all over again the same way......went through this about 4 times.......
Can anyone shed some light on this or possible cure for the problem
P.S.-I installed 3 different hard drives and it did this on every single one of them
USBEHCI.SYS is corrupted press key to continue, so I do that and then it says Setup Failed press key to reboot computer and then it does it all over again the same way......went through this about 4 times.......
Can anyone shed some light on this or possible cure for the problem
P.S.-I installed 3 different hard drives and it did this on every single one of them