34erd
New Member
I have the DFI lanparty ut nf4 sli-dr mobo. I'm reading through the manual and its really confusing. I have a couple of questions:
1. Do I need to clear the CMOS before starting up?
2. What should all th I/O's power be set to? Is the default 5V or 5VSB corect.
3. Should the speaker be on or off
4. What the hell are S/PDIF settings
5. Should I have to DRAM voltage set to up to 4 volts now?
6. What do I plug into S/PDIF power/input conector thingy
7. For the audio module the aoudio conector is for my front I/O's of my case right?
8. What do I do with the USB conectors on the baord do they go to my cases I/O?
9. Should I plug my SATA cables into 1-4 or 4-8 of the RAID controller if I'm not using RAID.
10. Which port should I stivk my SATA and ATA cables in. 1?
11.Whats a COM and IrDA conector?
12. Do the fans from my case get power from my mobo or the PSU? What are the fan conectors on my mobo for
13. And what about the internal IEEE 1394 conector?
14. If I have a 24 pin power conector on my PSU do I still need to use the 4 pin conector? I also plug the FDD and HDD power cables.
15. What about those wierd HDD LED, speaker, LED, ATX-SW power thingys what do I do with those.
I hope you guys can answer most of these, as you can tell I'm new to this lol
Basicly also just tell me evrything step by step...
Also when I was installing my floppy drive, I by accidently made the thing in the center turn... Is that ok?
1. Do I need to clear the CMOS before starting up?
2. What should all th I/O's power be set to? Is the default 5V or 5VSB corect.
3. Should the speaker be on or off
4. What the hell are S/PDIF settings
5. Should I have to DRAM voltage set to up to 4 volts now?
6. What do I plug into S/PDIF power/input conector thingy
7. For the audio module the aoudio conector is for my front I/O's of my case right?
8. What do I do with the USB conectors on the baord do they go to my cases I/O?
9. Should I plug my SATA cables into 1-4 or 4-8 of the RAID controller if I'm not using RAID.
10. Which port should I stivk my SATA and ATA cables in. 1?
11.Whats a COM and IrDA conector?
12. Do the fans from my case get power from my mobo or the PSU? What are the fan conectors on my mobo for
13. And what about the internal IEEE 1394 conector?
14. If I have a 24 pin power conector on my PSU do I still need to use the 4 pin conector? I also plug the FDD and HDD power cables.
15. What about those wierd HDD LED, speaker, LED, ATX-SW power thingys what do I do with those.
I hope you guys can answer most of these, as you can tell I'm new to this lol
Basicly also just tell me evrything step by step...
Also when I was installing my floppy drive, I by accidently made the thing in the center turn... Is that ok?