I had been running on of my boxes in a raid 0 config, using 2 250GB SATA II segatei clear hdds. connected into ports 1&2.
It then failed, now I am just trying to use the drives in JBOD but no matter what I try i can't read the drive plugged into port 1, by this i mean its no detected in POST or in the settings of bios.
the reason I believed it failed was because the power cable to drive 1 was out and when i cleared and deleted the array it did not have power, could this be the reason I cannont see it at all? because I cleared the array on one drive only?
can I some how use it again?
(oh and one that does work takes upward of 8 minutes to get bpast the xp loading bar?!?!)
It then failed, now I am just trying to use the drives in JBOD but no matter what I try i can't read the drive plugged into port 1, by this i mean its no detected in POST or in the settings of bios.
the reason I believed it failed was because the power cable to drive 1 was out and when i cleared and deleted the array it did not have power, could this be the reason I cannont see it at all? because I cleared the array on one drive only?
can I some how use it again?
(oh and one that does work takes upward of 8 minutes to get bpast the xp loading bar?!?!)
Last edited: