eddie57
Member
I just replaced the LCD on my laptop, but now windows won’t startup. I keep getting the following message:
“Windows did not start successfully, the reason a hardware or software change may have caused this.” It gives me the following options:
Safe mode
Safe mode with Networking
Safe mode with command prompt
Last known good configuration
Start windows normally
I tried them all and still windows does not start up. On a couple of the options I see a bunch of lines that say something like: multi disk partition windows system 32 drivers. There are some forward slashes in between the words and I believe all the lines end with the word “drivers”. They go by real fast so they are hard to see. It just keeps going to the message above “Windows did not start successfully, the reason a software or hardware change may have caused this” etc…
Any ideas what I can do? Any suggestions are appreciated. I used the original LDC Data cable and the bulb cable. The LCD appears to work fine; it's just windows won’t start up.
Thanks in advance,
Eddie
“Windows did not start successfully, the reason a hardware or software change may have caused this.” It gives me the following options:
Safe mode
Safe mode with Networking
Safe mode with command prompt
Last known good configuration
Start windows normally
I tried them all and still windows does not start up. On a couple of the options I see a bunch of lines that say something like: multi disk partition windows system 32 drivers. There are some forward slashes in between the words and I believe all the lines end with the word “drivers”. They go by real fast so they are hard to see. It just keeps going to the message above “Windows did not start successfully, the reason a software or hardware change may have caused this” etc…
Any ideas what I can do? Any suggestions are appreciated. I used the original LDC Data cable and the bulb cable. The LCD appears to work fine; it's just windows won’t start up.
Thanks in advance,
Eddie