Computer_Freak
Active Member
Hey guys
i have a Coolermaster Hyper 212 Plus
I basically put some thermal paste (Small vertical stripe) on each heatpipe.
the that the right way of doing it?
or do you apply it any other way?
cause between the heat pipe and the aluminium block, there is small gaps where the excess paste can "escape"
check it out, and tell me the correct way of applying paste on this type of heatsink.
This is the heatsink base. note the space between the pipes and the aluminium block
http://www.frostytech.com/articleimages/200907/CMhyper212plus_base.jpg
thanks guys
i have a Coolermaster Hyper 212 Plus
I basically put some thermal paste (Small vertical stripe) on each heatpipe.
the that the right way of doing it?
or do you apply it any other way?
cause between the heat pipe and the aluminium block, there is small gaps where the excess paste can "escape"
check it out, and tell me the correct way of applying paste on this type of heatsink.
This is the heatsink base. note the space between the pipes and the aluminium block
http://www.frostytech.com/articleimages/200907/CMhyper212plus_base.jpg
thanks guys
Last edited: