Post A Pic Of Your Pc Here :)

linkin

linkin

VIP Member
Basically I cut a strip of sandpaper, took the cover off the case, wrapped the sandpaper around and put the cover back on. Did that 3 times with each grit of sandpaper
 
just a noob

just a noob

Well-Known Member
Only reason I asked, is because it looked uneven on the gpu. If that's still nickel showing I would go ahead and lap some more to get down to all copper(or just delid it entirely).
 
linkin

linkin

VIP Member
I'll probably go over it again with the 600 grit and the 1200 grit, I didn't bother before because it was getting late :eek:
 
L

lhuser

New Member
Seriously, I'm fed of Mid-towers...
Excuse the gorrilla shaped images.
20101105145235.jpg

20101105145257.jpg

20101105145321.jpg


Yes, the cathodes are weirdly mounted, but it's just for now.
I'm still in the process of finishing its upgrade, then I'll put the cathodes in a better way.

There was the HAF 942 that I could of grabbed, but the two USB 3.0 kinda stinks, since I don't have a board for it AND I don't want to waste two USB ports in the back.
 
jasonn20

jasonn20

New Member
Nice linkin ^^ :good:

Have you tried your ram in the outer Dimm slots as it is supposed to be better for overclocking...
 
8

87dtna

Active Member
Archons?

Megahalems is one of the best air coolers there is... :D Better than a TRUE imo, maybe not quite as good as the copper though but close.
 
You must log in or register to reply here.
Top