Nothing really done today, bar a little problem.
I first fitted the Coolermaster 700W PSU (with love from
Specialtech. Its about 10mm shorter than the original test PSU I was using. I know I have to add in the length of the modual connections, but as I will only be using one of the Molex/S-ATA power ports, and one of the PCI-E power ports, it won't be a big problem.
It fits in at the back too which is nice.
Here is where the problem starts. When I started designing this mod, I didn't intend to use an Aquaero, but now I do and thats one of the reasons for
ze box. I didn't factor that in when designing mark two of the res.
Ooops. (those scratches are on the outer cover film, so all is well)
Well, I'm not desinging that res all over again
. Soo, I'm thinking that I'll dremel out part of the back of the box, and then add an
Acrylic Danger Den 90* bend to take it back towards the PSU. Its a little ennoying I know, but I promise it'll look good.
Or. I could just do away with the box on its own, and have the Aquaero 'floating' or the front panel.